Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Big Ass Fans Evaporative Cooler Cold Front 100

Create an account to install this asset package.

Maintenance Plans for Big Ass Fans Evaporative Cooler Model Cold Front 100

Integrate maintenance plans directly into your work orders in MaintainX.

1 Daily Cooler Maintenance

WARNING ELECTRICAL SHOCK HAZARD: Disconnect the power supply before performing any service or maintenance. Failure to do so may result in serious injury or death.

Turn off the pump about 15 minutes before the fan is turned off to allow the pads to drain and dry out.

Drain the water from the cooler if it will be unused for a prolonged period of time.

Sign off on the daily cooler maintenance

Run this procedure

1 Weekly Cooler Cleaning

WARNING ELECTRICAL SHOCK HAZARD

Disconnect the power supply before performing any service or maintenance. Failure to do so may result in serious injury or death.

Removing the cooling media

Remove the cooling pads to access the inside of the cooler.

1. Remove pad grilles from support channel.

2. Tilt pads from the top and lift out of the cooler.

Drain and clean the cooler weekly. Remove the cooling media and wash with a garden hose.;

Run this procedure

1 Weekly Water Sump Draining

WARNING ELECTRICAL SHOCK HAZARD

Disconnect the power supply before performing any service or maintenance. Failure to do so may result in serious injury or death.

Removing the cooling media

Remove the cooling pads to access the inside of the cooler.

1. Remove pad grilles from support channel.

2. Tilt pads from the top and lift out of the cooler.

Draining the water sump

Depending on how often you operate the cooler, drain the sump anywhere from every week for heavy use to monthly for light use.

1. Turn cooler off and disconnect the power supply.

Run this procedure

Cooler Check

CHECKLIST

DO:

• Check all hose connections.

• Use a 12 gauge cord if the cord is under 50 ft (15 m) or a 10 gauge cord if the cord is over 50 ft (15 m).

• Provide fresh air intake for the cooler and maintain a minimum clearance of 3 ft (0.9 m) behind the cooler.

• Flush new cooling media.

1. Fill the cooler with water.

2. Switch on the pump.

3. Run the cooler without the fan running for 5 hours.

Run this procedure

Cooling Media Cleaning

WARNING ELECTRICAL SHOCK HAZARD

Disconnect the power supply before performing any service or maintenance. Failure to do so may result in serious injury or death.

Removing the cooling media

Remove the cooling pads to access the inside of the cooler.

1. Remove pad grilles from support channel.

2. Tilt pads from the top and lift out of the cooler.

Periodic maintenance

The cooling pads act as a filter to remove dust and other particles from the incoming air stream. The collected particles and any water impurities will flow into the sump and collect there. To keep the cooler operating at peak efficiency, keep the cooling media and sump clear of debris.

Cleaning the cooling media

Run this procedure