Atlas Copco Shut-off Pulse Tool EP7PTI55 HR10-MT

Tool is in good condition, no visual damage

Air connection and air installation is done correctly

Sockets and extensions have no visual damage

No unexpected noise when running the tool

Carry out maintenance after 200 000 - 250 000 tightening or once a year whichever comes first

Make a visual inspection for any damage

Enter the number of tightenings

Open and inspect the parts for damage, wear or blockage

Clean the needle valve (only AutoTrim)

Change the sealing if needed (only AutoTrim)

Assemble and adjust according to instructions

Sign off on the AutoTrim/Trim maintenance

Inspection of the shut-off mechanism

Inspection of the square drive and hex drive for any cracks or wear

Check if the torque adjustment screw has enough friction to prevent the setting from accidentally changing during operation

Change the oil according to the manufacturer's instructions

Check if the pulsing frequency is within limits, as per the Tool Condition Test

Check if Trigger and Reversing Valve works correctly

Inspect the O-rings and washer, replace if needed in Trigger and Reversing Valve

Open and inspect the parts of Silencer for damage, replace if needed