Atlas Copco Oil-Injected Rotary Screw Compressor GA30VSD+

Check oil level. If needed, top up the oil

Check that condensate is discharged during operation

Compressor stopped, air outlet valve closed and voltage switched off

Dirt on the condenser inlet removed with a vacuum cleaner

Cleaned with an air jet in the reverse direction to normal flow using low pressure air

Compressed air nozzle kept more than 30 cm away from the condenser

Dust from inside the dryer removed, e.g. with a vacuum cleaner

Water or solvents not used to clean the condenser

Sign off on the condenser cleaning

Check coolers, clean if necessary

Remove the air filter element and inspect. Replace damaged or heavily contaminated elements

Check the filter elements of the electric cabinet. Replace if necessary

Warning: Ensure the compressor is stopped and voltage is switched off before proceeding.

Compressor stopped and voltage switched off?

Remove the cover of the air filter (AF) by turning it anti clockwise.

Fit the new element and the cover.

Reset the air filter service warning.

Stop the compressor, close the air outlet valve and switch off the voltage

Cover all parts under the coolers

Remove the service plate at the fan compartment

Remove dirt from the coolers with a fibre brush. Brush in the direction of the cooling fins

Remove dirt from the fan with a fibre brush

Clean with an air jet in the reverse direction to normal flow

If it is necessary to wash the coolers with a cleaning agent, consult Atlas Copco

Mount the service plate (1) at the fan compartment

CAUTION! After maintenance on the fan and on the coolers: Remove the loose parts that are used as cover