TGW Narrow Belt Sorter NBS BR 10M

Listen for unusual noises or vibration

Visually inspect to see that conveyor sections are clear and free of debris

Check to see that all safety guards are in place

Check for any unusual noises or vibration

Check air filter bowls for accumulated water

Drive unit unusual noises check

Inspect bearings and motors for excessive noise or heat

Clean breather cap on Gearmotor (if used)

Check operation of all electrical controls

Check for proper PSI on air regulators

Sign off on the weekly maintenance

Inspect tightness of all nuts and bolts on units. Re-adjust and, if necessary, retighten

Check for plumb and level. Shims have been known to vibrate out from under supports in isolated incidents

Touch up paint that has been chipped. Unpainted surfaces will rust

Inspect for stress/fatigue cracks in frame and supports

Pulley and timing belts should be checked annually. Look for correct alignment. In time, set screws may loosen and allow the pulleys to become misaligned. Use a straight edge held parallel to both pulleys to check alignment. Shift one of the pulleys if the straight edge shows it is necessary

Inspect and clean motor control centers

Check the condition of contacts on all contactors and starters

Check spring pressure during contact condition inspection

Check for excessive deposits of foreign materials

Reposition or replace defective gaskets and clean the control cabinet

Check all overload settings on motor controls

Check for loose wiring and tighten as required