SPX Flow Centrifugal Pump WS+ 20/15

Safety Information! All electric/electronic installation, maintenance, and service must be performed by trained and authorized electricians only.

All installation, maintenance, and service of piping, valves, and other controls must be performed by trained and authorized plumbers only.

All plumbing installation must comply with all applicable codes and standards including those established by OSHA.

Do Not perform any maintenance or service on the motor or pump unless the power source has been turned off and Locked Out.

Never disconnect any lines or fittings or disassemble the pump until the line is no longer under pressure and the fluid inside is not hot or harmful.

Operating personnel must be authorized and trained.

Always clean up leaks and spills immediately.

Find and correct the cause of the leak immediately.

Pump working properly after pouring water and starting it for a moment?

Safety Information! All electric/electronic installation, maintenance, and service must be performed by trained and authorized electricians only.

All installation, maintenance, and service of piping, valves, and other controls must be performed by trained and authorized plumbers only.

All plumbing installation must comply with all applicable codes and standards including those established by OSHA.

Do Not perform any maintenance or service on the motor or pump unless the power source has been turned off and Locked Out.

Never disconnect any lines or fittings or disassemble the pump until the line is no longer under pressure and the fluid inside is not hot or harmful.

Operating personnel must be authorized and trained.

Always clean up leaks and spills immediately.

Find and correct the cause of the leak immediately.

Power supply in the motor isolator disconnected?

Safety Information! All electric/electronic installation, maintenance, and service must be performed by trained and authorized electricians only.

All installation, maintenance, and service of piping, valves, and other controls must be performed by trained and authorized plumbers only.

All plumbing installation must comply with all applicable codes and standards including those established by OSHA.

Do Not perform any maintenance or service on the motor or pump unless the power source has been turned off and Locked Out.

Never disconnect any lines or fittings or disassemble the pump until the line is no longer under pressure and the fluid inside is not hot or harmful.

Operating personnel must be authorized and trained.

Always clean up leaks and spills immediately.

Find and correct the cause of the leak immediately.

Check the pump's shaft seal for leaks

Safety Information! All electric/electronic installation, maintenance, and service must be performed by trained and authorized electricians only.

All installation, maintenance, and service of piping, valves, and other controls must be performed by trained and authorized plumbers only.

All plumbing installation must comply with all applicable codes and standards including those established by OSHA.

Power source has been turned off and Locked Out?

Lines or fittings are no longer under pressure and the fluid inside is not hot or harmful?

Operating personnel is authorized and trained?

Leaks and spills cleaned up immediately?

Cause of the leak found and corrected immediately?

Lock Out power supply then disconnect the pump and motor from system.