Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Nordson Reciprocator HF30 320

Create an account to install this asset package.

Maintenance Plans for Nordson Reciprocator Model HF30 320

Integrate maintenance plans directly into your work orders in MaintainX.

Belt Replacement

ATTENTION: to perform this maintenance two persons are necessary.

Power supply to the machine turned off

Gun supporting-arm removed

Rear door removed

Main panel removed by unscrewing the screws that fix it to the main structure

Gun supporting-arm positioned and blocked so as the counterweight is in line with the opening

Operated on the nuts to slacken or tension the belt

All the counterweight plates removed as per Chapter 12.8

Belt marked (up and down) to locate the assembly position

Run this procedure

Belt Tension Adjustment

Power supply to the machine turned off

Rear door removed and trolley moved

Operated on the nuts to adjust belt tension

Checked the plates are parallel that clamp the belt

Enter the belt tension as per the diagram

Rear door assembled back

Sign off on the belt tension adjustment

Run this procedure

Counterweight Adjustment

Power supply to the machine turned off

Rear door removed

Trolley moved so that the counterweight slides up/down to reach the opening

ATTENTION: to make the work easier and for safety reasons, it is better that the following operations are carried out by two operators.

Plates of the counterweight added or removed to balance the machine

Rear door assembled

Sign off on the counterweight adjustment

Run this procedure

Counterweight Sliding Guides Replacement

Turn off the power supply to the machine

Remove the rear door

Position and block the gun supporting-arm so as the counterweight is in line with the opening

Refer to Chapter 12.8 to remove all the counterweight plates

Operate on the nuts, indicated in the picture 30, to slacken the belt

Tilt sideways the counterweight plate, shown in the figure, so as to remove the sliding guides from its seats with a suitable wrench

ATTENTION: it is necessary to hold the counterweight structure so as to avoid that it falls down. Hence a second operator is required for safety reason

Replace them with new counterweight guides

Adjust the belt tension (see the relative Chapter)

Run this procedure

Encoder Replacement

Power supply to the machine turned off

Upload a photo of the front safety guard removed

Upload a photo of the junction box opened and encoder disconnected

Joint clamp near the encoder loosened and screws unscrewed

Upload a photo of the new encoder assembled on the support

Encoder connected to the junction box

Upload a photo of the closed junction box and front safety guard of the machine

Sign off on the encoder replacement