Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Nordson Reciprocator HF80 270

Create an account to install this asset package.

Maintenance Plans for Nordson Reciprocator Model HF80 270

Integrate maintenance plans directly into your work orders in MaintainX.

Belt Replacement

ATTENTION: to perform this maintenance two persons are necessary.

Power supply to the machine turned off

Gun supporting-arm removed

Rear door removed

Main panel removed by unscrewing the screws that fix it to the main structure

Gun supporting-arm positioned and blocked so as the counterweight is in line with the opening

Two+two nuts A of the rod and the two upper screws B unscrewed to slacken the belt and remove it from the pulley

All the counterweight plates removed as per Chapter 12.8

Belt marked (up and down) to locate the assembly position

Run this procedure

Belt Tension Adjustment

Warning: Ensure the power supply to the machine is turned off before starting the procedure.

Power supply to the machine turned off

Rear door removed and trolley moved so that the counterweight slides up/down to reach the opening

Two+two nuts A of the rod and the two upper screws B unscrewed to tension or slacken the belt

Refer to the table for correct belt tension values

Parallelism between the upper and the lower counterweight plates checked

Rear door assembled

Sign off on the belt tension adjustment

Run this procedure

Counterweight Adjustment

Power supply to the machine turned off

Rear door removed

Trolley moved so that the counterweight slides up/down up to reach the opening

ATTENTION: to make the work easier and for safety reasons, it is better that the following operations are carried out by two operators.

Plates of the counterweight added or removed to balance the machine

Rear door assembled

Sign off on the counterweight adjustment

Run this procedure

Counterweight Sliding Guides Replacement

Turn off the power supply to the machine

Remove the rear door

Position and block the gun supporting-arm so as the counterweight is in line with the opening

Refer to Chapter 12.8 to remove all the counterweight plates

Unscrew the two+two nuts A of the rod and the two upper screws B, with a suitable wrench, so as to slacken the belt and remove it from the pulley

ATTENTION: do not remove the screws completely so as to avoid that the counterweight and the trolley fall

Tilt sideways the counterweight plate, so as to remove the sliding guides from its seats with a suitable wrench

ATTENTION: it is necessary to hold the counterweight structure so as to avoid that it falls down. Hence a second operator is required for safety reason

Replace them with new counterweight guides

Run this procedure

Encoder Replacement

Power supply to the machine turned off

Upload a photo of the removed front safety guard

Junction box opened and encoder disconnected

Joint clamp near the encoder loosened and screws unscrewed

New encoder assembled on the support, shaft inserted into the hose of the joint and blocked with the relative clamp

Encoder connected to the junction box

Junction box and the front safety guard of the machine closed

Sign off on the encoder replacement

Run this procedure