Mori Seiki CNC Lathe DuraTurn 2050

WARNING! Turn OFF the main power and disconnect the plantside power supply (breaker). Use a ladder or service platform when working in elevated places. Loss of balance may result in serious injury

CAUTION! If foreign matter adheres to the fan, it impairs cooling performance. Clean the fan periodically. Dust and dirt may damage the filter and prevent air flow. Clean the filter periodically. Do not wash the filter by hand. The filter may gradually deteriorate after being cleaned about 5 - 10 times. If the filter deteriorates, replace it with a new filter

Disconnect the plant-side power supply (breaker)

NOTE! Take care not to let the fan body fall when the screws are removed

Drain pan placed beneath the drain plug?

Drain plug removed and oil drained?

Enter the oil level gage reading

Pump pressure and suction noise are normal?

WARNING! Turn OFF the main power

Suction filter and fill port filter removed

CAUTION! Protective glasses must be worn to prevent eye damage form dust or foreign matter (those who are wearing glasses included)

Inside of the tank cleaned with a neutral detergent

Sign off on the lubricant tank cleaning

WARNING! Turn OFF the main power

Rotate the valve CW to shut off the compressed air supply

Turn the manual drain cock in the counterclockwise direction to release residual pressure

Confirm the pressure gage indicates 0 MPa

Inspect/replace the air filter element

Removing Air Filter Assembly Case

Slide the lock button downward and rotate the assembly case 45 degrees CW or CCW

Pull the assembly case downward to remove

NOTE! Refer to the steps 3) - 5) in "Replacing Oil" (page 2-346)

3) Remove the bolts beneath the tank and pull the hydraulic unit out from the base

7) Clean the suction strainer using the following procedure