Mitutoyo Depth Gage 7222A

Warning: Do not use organic solvents such as thinner, which may deform the product.

Clean the sliding surface of the plunger with a dry cloth or cloth slightly moistened with alcohol.

Ensure the plunger is not lubricated.

Clean the crystal with a soft cloth moistened with diluted neutral detergent.

Sign off on the cleaning procedure

NOTICE: Shows risks that could result in property damage.

Mounting: Lift the plunger and fit the stop screw (A) between the tips of the lifting lever.

Mounting: Fit the grooves of the lifting lever into the dovetail groove and move it in the direction of the arrow to secure it.

Removing: Push up the finger rest part and remove the lifting lever.

Mounting the bezel clamp: Fit the clamp bracket (A) into the dovetail groove.

Mounting the bezel clamp: While pressing the clamp bracket (A) with the clamp plate (B), tighten the clamp screw (C).

NOTICE: The clamp screw may loosen and fall off due to vibration, etc.

Caution: Shows risks that could result in minor or moderate injury.

Mounting the limit hand: Hook the hand limit on the bezel.

Pointer, short pointer, and plunger move smoothly

Pointer and short pointer maintain the set stop points when they stop

Contact point and screws are not loose

Measurement point is too deep for the contact point to reach

Rods are supplied with the following models as a standard accessory

Use a combination of extension rods depending on the dimension to measure

NOTICE: Shows risks that could result in property damage