Lenovo Business Laptop ThinkPad T16 Gen 3

Turn off the computer and disconnect from AC power and all connected cables

Close the computer display and turn over the computer

Remove the M.2 solid-state drive

Remove the M.2 solid-state drive bracket

Backup all important data from the M.2 solid-state drive

Turn off the computer and disconnect from AC power and all connected cables

Close the computer display and turn over the computer

M.2 Solid-State Drive Handling Precautions

Observe the following guidelines when handling the M.2 solid-state drive

M.2 Solid-State Drive Replacement

Use only Lenovo-authorized battery specified for the computer.

Do not open, disassemble, or service any battery unless competent to do so.

Do not crush, puncture, or short-circuit the battery.

Keep the battery away from children and fire.

Stop using the battery if it is damaged or shows signs of discharge.

Store batteries at room temperature, charged to 30-50% capacity.

Do not dispose of the battery in landfills; comply with local regulations.

Attention: Do not touch the contact edge of the memory module.

Turn off the computer and disconnect from AC power and all connected cables.

Close the computer display and turn over the computer.

Remove the base cover assembly.

Remove the memory module shielding cap.

Memory Module Installation Order

Read Generic Safety and Compliance Notices

Turn off the computer and disconnect from AC power and all connected cables

Loosen the screws that secure the keyboard

Push the keyboard to release the latches from the keyboard bezel

Pivot the keyboard slightly upward and turn it over

Place the keyboard on the palm rest and detach the connectors