Kenworth Truck Company Vehicle T-880

NOTE: These checks are in addition to, not in place of, Federal Motor Carrier Safety Regulations. These regulations may be purchased by writing to: Superintendent of Documents U.S. Government Printing Office Bookstore 710 N. Capitol St. N.W. Washington, DC 20402, or ContactCenter@gpo.gov.

• Fuel filter (water separator) Fuel System on page 312.

• Battery cables - check the condition of the battery and alternator cables for signs of chafing or rubbing. Make sure that all clamps (straps) holding the cables are present and in good working order.

Check the kingpin lock and plate for wear and function

Check for proper function of Front Suspension - Spring Pins

Check the general condition and the tightness of the nuts of Front Suspension - U-bolts

Check oil level of Drive Axle - Vocational (PACCAR) - Axle Assembly

Visually inspect for damage or leaks in Drive Axle - Vocational (PACCAR) - Axle Assembly

Check the operation of Drive Axle - Vocational (PACCAR) - Breather

Check the 'cold' fill level at the differential carrier plug for a pinion angle of less than 7 degrees, or at the axle bowl plug for a pinion angle of greater than 7 degrees in Drive Axle (Meritor City Delivery / OFF HIGHWAY) - Axle Housing

Visually inspect for damage or leaks in Drive Axle (Meritor City Delivery / OFF HIGHWAY) - Axle Housing

Check the operation of Drive Axle (Meritor City Delivery / OFF HIGHWAY) - Breather

NOTE: These checks are in addition to, not in place of, Federal Motor Carrier Safety Regulations. These regulations may be purchased by writing to: Superintendent of Documents U.S. Government Printing Office Bookstore 710 N. Capitol St. N.W. Washington, DC 20402, or ContactCenter@gpo.gov.

• Engine Aftertreatment system components

Warning: This procedure requires trained personnel with PPE!

If axle is not warm, warm it up before proceeding

Enter the current mileage of the vehicle

Choose the type of lubricant used

Drain the lubricant while warm. Flush each unit with clean flushing oil. Change the lubricant.

Was the original mineral-based lubricant drained within 3,000-5,000 miles (4,800-8,000 km)?

Was the lubricant changed within the first 5,000 miles (8,000 km) of operation after a carrier head replacement?

Enter the brand of the Eaton-approved lubricant used

Frame - Crossmembers and Mounting Brackets

Front Axle - Linehaul (PACCAR) - Steer Axle Wheel Ends: Oil Bath (Adjusted)

Front Axle - Linehaul (PACCAR) - Steer Axle Wheel Ends: Oil Bath (Adjusted)

Front Axle - Linehaul (PACCAR) - Steer Axle Semi-fluid (Adjusted)

Front Axle - Linehaul (PACCAR) - Steer Axle Grease Pack (Adjusted)

Front Axle - Vocational (PACCAR) - Steer Axle Wheel Ends: Oil Bath LMS

Drive Axle - Linehaul (PACCAR) - Axle Shaft

Drive Axle - Vocational (PACCAR) - Axle Shaft