Mercer Valve Pressure Relief Valve 91-17E51V05I1

Warning: This procedure requires trained personnel!

Are two pressure gauges used for testing?

Are the gauges reading identical values within their respective tolerances?

Select the type of the first gauge

Select the type of the second gauge

Is the analog (dial) gauge not liquid filled?

Does the digital gauge respond to quick pressure increases?

Enter the accuracy of the test gauges over their full scale

Is the tolerance of the gauge used more stringent than the set pressure’s tolerance?

Warning: This inspection requires trained personnel with PPE!

Enter the set pressure of the valve

Contact Mercer Valve Co., Inc. for proper leak pressure and specification for the valve

Pressure held steady during the test?

Any leakage observed during the test?

Before this test is performed, the valve must have had its set pressure examined

Leakage test as per API STD 527 passed?

Warning: This maintenance check requires qualified repair personnel!

Is the PRV correct for the application?

Are there any apparent problems with the PRV?

Is the nameplate information correct?

Is there any damage to the valve?

Are there any issues that would keep the valve from opening or inhibit flow?

Are there any problems found during the visual inspection?

Warning: This inspection requires trained personnel with PPE!

The set pressure inspection is performed in accordance with the ASME BPVC.

The set pressure tolerance is calculated based on the actual nameplate set pressure.

The set pressure test should be performed before and after any repairs.

The correct fluid for testing has to be used to achieve accurate results.

Setting procedures should be in accordance with ASME PTC 25.

The rate of the system pressure increase should be slow when the pressure is within 15% of the set pressure.

The procedures for testing set pressure are as follows.

Check the set pressure definition from NB-18.

Warning: Ensure the valve is not pressurized before starting the inspection

Cap and Seal Wire in good condition

Flanged Connections in good condition

Threaded Connections in good condition

Outlet free from corrosion or debris

External Surface free from damage

Valve Tag information corresponds to service conditions

Valve passed the visual inspection

Issues found during the inspection