Keating of Chicago Electric Griddle 72x30

WARNING: DISCONNECT ELECTRIC POWER SOURCE BEFORE CLEANING

Clean grease build-up on switches

Clean grease build-up on thermostat knobs

NOTE: If grease gets into the body of the switch or thermostat, it may cause it to fail

WARNING: IF GREASE GETS INTO THE BODY OF THE SWITCH OR THERMOSTAT, IT MAY CAUSE POSSIBLE ELECTRICAL SHOCK

Clean the cabinet surfaces for sanitary reasons

Set thermostat to desired temperature

Allow thermostat to cycle three times

Locate 'L' on front of griddle plate above thermostat

Place thermometer on plate over bulb halfway toward rear of griddle

Check if calibration of griddle is less than 15°F off

Loosen three dial plate retaining screws

Rotate dial plate to match thermometer reading

Scrape MIRACLEAN® surface with the Keating Scraper

Clean with potable tap water and a Keating palmetto brush

Polish surface with Keating Klenzer

Rinse with potable water to remove excess Keating Klenzer

Inspect the surface for any remaining residue

Hand wash spatulas in mild to medium strength detergent

Avoid contact with Chlorine or bleach

Rub spatula with vegetable oil to slow discoloration

Carefully wipe blade with a dry cloth

Cover blade with plastic protection cover when not in use

Surface Condition and Procedures Review

Check condition of MIRACLEAN® surface

Review proper procedures for using the MIRACLEAN® surface

Measure the current temperature setting of the thermostat

Is the thermostat calibrated correctly?

Installation and Operating Instructions Review

Review installation instructions received with the griddle

Review operating instructions received with the griddle