HINO Commercial Truck 258LP

Engine oil inspection, oil supply and discharge

Cooling water inspection, water supply and discharge

Transmission oil inspection, oil supply and discharge (Special care is needed when installing P.T.O.)

Differential oil inspection, oil supply and discharge (Care is needed when spare tire is mounted on the rear overhang.)

Grease up (Special care is needed when shifting the fuel tank on vehicles.)

Battery liquid inspection, water supply and discharge.

Warning: This maintenance check requires trained personnel with PPE!

Is there sufficient working space for dismounting and mounting the air dryer?

If there is not sufficient space, clear the area before proceeding

Air dryer successfully dismounted?

Desiccant inspected and in good condition?

Choose the type of service done

Air dryer successfully mounted?

Sign off on the air dryer desiccant maintenance

Warning: The exhaust system becomes very hot during operation. Maintain adequate clearances.

Clearances from a body or equipment observed

Enter the clearance between the fuel tank, fuel pipes and hot components of the exhaust system

If clearance is less than 200mm, are heat shields or insulators fitted?

Fuel piping arranged so that no fuel will come into contact with the hot components of the exhaust system if a fuel line ruptures

Are connectors of the fuel pipes installed away from the hot components of the exhaust system?

Clearances from chassis parts other than fuel system parts maintained

If clearances are not maintained, are heat insulators or heat shields fitted?

Sign off on the exhaust system maintenance

Warning: This maintenance check requires trained personnel with PPE!

Identify harmful defects such as breakage, crush, perforation, etc.

Specify the position of the defect on the nylon tube

Cutting face of the nylon tube is smooth without any burr and that the cutting face is 90º±5º to the axis of the nylon tube

Wind the inserting margin taping according to the following table. (In the same way as in the case of one-touch type connector )

Remount the connector according to the dismounting and remounting procedures of the nylon tube.

Securely fix the repair connector with a clamp to the nylon tube protected with corrugated tube existing around it.

If corrugated tube does not exist around it, add the corrugated tube.

If repair work is difficult to carry out for the reason of layout or for the reason of influencing on the external appearance such as on the air tank or that the tube is relatively short and its replacement can be done easily, replace the nylon tube with a new one.

Reinstall each electronic equipment to original place

Inspect the operation and function of all electronic equipment

For the detail of inspection’s procedure, please consult HMS (USA) or Hino authorized dealer.