Hatco Heated Display Case GRCDH-3P

Read all safety messages in the IMPORTANT SAFETY INFORMATION section before operating this equipment.

Ensure food product is wrapped, boxed, or on a food pan before placing on shelves.

Plug unit into a properly grounded electrical receptacle of the correct voltage, size and plug configuration.

Startup - GRCD and GRHD (Non-Humidified) Models

Move the Power I/O (on/off) switch on the base to the I (on) position.

Set the BASE HEAT CONTROL to the desired temperature setting.

Set the TOP HEAT CONTROL and the CENTER HEAT CONTROL (dual units only) to the desired temperature setting.

Turn off the unit and unplug the power cord

Wipe down all exterior and interior surfaces

Use a non-abrasive cleaner for difficult stains

Clean hard to reach areas with a small brush and mild soap

Clean the interior of the unit thoroughly

Ensure only NSF standard light bulbs are used

Verify light bulbs are specially coated to prevent injury and contamination

Unscrew the existing light bulb

Is the unit turned off and unplugged?

Water Reservoir Removal and Emptying

Remove the water reservoir cover and water reservoir

Deliming Mixture Preparation and Application

Fill the water reservoir with a mixture of 75% water and 25% white vinegar

Move the Power ON/OFF (I/O) switch to the OFF (O) position and unplug the power cord.

Remove all components inside of the unit.

Remove the glass door(s) and side panel(s).

Carefully lay the unit on its side.

Remove the 4′′ (102 mm) legs from the bottom of the unit.

Remove all screws on the bottom panel of the unit and remove the bottom panel.