Hatco Double Shelf Warmer GRSDS-41

Wipe exterior and interior surfaces with a damp cloth

Remove stubborn stains with a non-abrasive cleaner

Clean hard to reach areas with a small brush and mild soap

Clean the glass sides using a common glass cleaner

Do not use abrasive cleaners to avoid scratching the finish

Avoid using jet-clean-spray on the appliance

LED Temperature Control Overview

Turn the red Mode Switch counterclockwise to the SP-1 position indicated on the controller.

Adjust the Setpoint Screw to the desired temperature (°C or °F).

Turn the red Mode Switch to the TEMP position.

Ensure the unit is over 91 cm (36") in length or weighs more than 36 kg (80 lbs.)

Can the unit be sealed at the point of use?

Carefully lay unit on its side, avoiding the side with the control panel

Install 10 cm (4") legs to the bottom of the unit

Hand tighten legs until snug, ensuring not to overtighten

Return unit to the upright position

Unscrew the old light bulb from the unit

Select the appropriate replacement light bulb

Install the new specially-coated incandescent light bulb

Ensure the light bulb meets N.S.F. standards for food holding areas