Hatco Strip Heater GRSBF-48-O

Turn off the unit and unplug the power cord

Has the unit cooled down completely?

Were all food pans washed, if necessary?

Wipe down all metal surfaces with a non-abrasive, damp cloth

Describe any stubborn stains and cleaning methods used

Clean hard to reach areas using a small brush and mild soap

Changing the Setpoint Temperature

Press the key three times to display the current setpoint temperature

Press the key or key within 10 seconds to change the setpoint temperature

Press the key to lock in the new setpoint temperature

Changing Fahrenheit and Celsius Setting

Press the key once to display current temperature unit

Press the key or key within 10 seconds to change between Fahrenheit and Celsius

Press the key three times to lock in the new setting

Turn off the unit and unplug the power cord

Installation of Adjustable Legs

Carefully turn the unit upside down and lay it on a flat surface

Cover the surface to prevent scratching the unit

Thread a 102 mm (4′′) leg into each corner of the unit and hand-tighten until snug

Return the unit to the upright position

Adjust the temperature control clockwise to increase the setpoint temperature

Adjust the temperature control counterclockwise to decrease the setpoint temperature

Read all safety messages in the IMPORTANT SAFETY INFORMATION section before operating the equipment.

Plug unit into a properly grounded electrical receptacle of the correct voltage, size, and plug configuration.

Move the Power On/Off (I/O) switch to the On (I) position.

Set the thermostat control to the desired temperature setting.