Hatco Double Shelf Warmer GRSDH-36

Ensure the unit is over 91 cm (36") in length or weighs more than 36 kg (80 lbs.)

Verify that the unit cannot be sealed at the point of use

Carefully lay the unit on its side, avoiding the side with the control panel

Install 10 cm (4") legs to the bottom of the unit

Hand tighten legs until snug, ensuring not to overtighten

Return the unit to the upright position

Verify LED Temperature Control Features

Turn the red Mode Switch counterclockwise to the SP-1 position

Adjust the Setpoint Screw to the desired temperature (°C)

Turn the red Mode Switch to the TEMP position

Use only non-abrasive cleaners.

Abrasive cleaners could scratch the finish of the Glo-Ray Merchandising Warmer, marring its appearance and making it susceptible to dirt accumulation.

To preserve the bright finish of the Glo-Ray Merchandising Display Warmer, wipe the exterior and interior surfaces daily with a damp cloth.

Stubborn stains may be removed with a good non-abrasive cleaner.

Hard to reach areas should be cleaned with a small brush and mild soap.

Clean the glass sides using a common glass cleaner.

Unscrew the old light bulb from the unit

Select the appropriate replacement light bulb

Install the new specially-coated incandescent light bulb

Ensure the light bulb meets N.S.F. standards for food holding areas