Gardner Denver Compressor EBH99G

Unit stopped and no air pressure in the oil reservoir

Gasket face of the filter body cleaned

New element gasket coated with clean lubricant used in the unit

New element screwed on the filter body and tightened by hand

Warning: Do not over tighten the element

Sign off on the oil filter element replacement

Check for dirt accumulation on oil/aftercooler core faces and the cooling fan.

If cleaning is required, follow the steps below:

Was the cleaning operation successful?

This cleaning operation will keep the exterior cooling surfaces clean and ensure effective heat dissipation.

Sign off on the 125 Hourly Oil, Aftercooler and Cooling Fan Check

1. Check the relief valve for proper operation.

To test the relief valve, raise the system operating pressure to 75% of the relief valve set pressure and manually open the valve with the hand lever.

Hold the valve open for a few seconds and allow it to snap shut.

2. Check shutdowns for proper operation.;

Change the compressor lubricant.

UNDER ADVERSE CONDITIONS, CHANGE MORE FREQUENTLY. Flush system if required.

LUBRICANT CHANGE PROCEDURE - Following are the primary steps to be completed when upgrading or changing the type of lubricant.

- Drain oil from air end and cooler while hot.

- Break low point connections and drain oil from pipe runs.

- Dump oil from the filter and reinstall used filter.

2. Fill the system with a 50 percent charge of the new lubricant:

- Start the machine and stay there to observe.

Check the reservoir oil level - add oil if required. If oil consumption is high, refer to “Excessive Oil consumption, page 71. DO NOT MIX LUBRICANTS.

Observe if the unit loads and unloads properly.

Check Panel LED’s for advisories.