Gardner Denver Compressor EFC99J02E

Power supply to the starter disconnected, locked out and tagged out

Motor base jacked up using adjusting screws to loosen belt tension

Bolts from tapered bushing removed

Sheave pulled off the rotor shaft with a gear puller, if necessary

New sheave and tapered bushing installed

New belts installed. Belt tension checked and wire guard reattached

Sheaves aligned with a straight edge

Check the reservoir oil level - add oil if required

Observe if the unit loads and unloads properly

Check control panel display for advisory text messages

Check for dirt accumulation on oil/aftercooler core faces and the cooling fan

Clean the exterior fin surfaces of the cores by blowing compressed air carrying a nonflammable safety solvent in a direction opposite that of the cooling fan air flow

Change the oil filter element every 1000 Hour

Change the compressor lubricant AEON 4000

Change the compressor lubricant AEON 9000SP

Sign off on the 125 Hour Maintenance

Power supply to the starter disconnected, locked out and tagged out

Motor base jacked up using adjusting screws and belt tension loosened

Belts tightened using the adjust screws and correct belt tension checked

Sign off on the compressor belt replacement

Is the unit off and no air pressure in the air/oil reservoir?

Is the air service valve located after the compressor package discharge closed?

Is the power supply to the starter disconnected, locked out, and tagged out?

Is the air filter cover removed?

Is the inside of the air filter housing cleaned?

Is the new air filter element and the air filter cover installed?

Is the element replaced if visual inspection indicates an accumulation of dirt, or a rupture, crack or pin holes in the pleated media?

Is the inspection done by placing a bright light inside the element?