Esco Micro Laminar Flow Clean Bench AVC-2D3

Ensure power cord is detached from the main power supply inlet

Replace the disposable pre-filter

Inspect for physical abnormalities or malfunctions

Stainless Steel Surface Cleaning

Clean stainless steel surfaces with MEK

Wash the steel surface with clean water and liquid detergent

Wipe the work surface, side walls, and inner back walls with appropriate disinfectant

Did you follow up with a 70% ethanol rinse?

Ensure no chlorine-based disinfectants were used

Ensure only hands entered the clean bench during cleaning

Ensure the clean bench is powered down

Disconnect the clean bench from the electrical supply

Remove the power clips at the ends of the bulbs

Remove the bulbs from the mounting clips

Replace the power clips on the ends of the new bulbs

Clean the exterior surfaces of the cabinet with a damp cloth

Check all service fixtures for proper operation

Note any issues with service fixtures

Verify clean bench airflow velocities and flow patterns against manufacturer's specifications and international standards.

Scan-test filters to ensure they do not leak.

Perform operator comfort tests, if applicable.

Adjust airflow velocities if found to be off setpoint before recording final values.

Disconnect the electrical connections.

Remove the old UV lamp by rotating 90 degrees counter-clockwise and pulling downward.

Install the new UV lamp by pushing it upward and rotating 90 degrees clockwise.