Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

DMG Mori Turning Center NLX2500MC/700

Create an account to install this asset package.

Maintenance Plans for DMG Mori Turning Center Model NLX2500MC/700

Integrate maintenance plans directly into your work orders in MaintainX.

Bolt Replacement

DANGER! Turn the power OFF before performing maintenance and inspection procedures. If absolutely necessary to work with the power ON, exercise extreme caution.

Electrical wiring work is to be performed by qualified electrical technicians only.

Main power switch is turned [OFF] and locked

Door is open when working inside the machine

Provide clear warning that the machine is being maintained and operations cannot be performed.

Plant side power supply (circuit breaker) is turned OFF

Maintenance procedures undertaken with the power turned ON must be performed by qualified electrical engineers.

Electrical cabinet doors or the operation panel are closed except to perform maintenance and inspection procedures.

Hydraulic unit, coolant pump, solenoid valves and servomotors are not touched during, or immediately after operation

Run this procedure

Chuck Gripping Force Measurement

DANGER! Turn the power OFF before performing maintenance and inspection procedures. If absolutely necessary to work with the power ON, exercise extreme caution.

Electrical wiring work is to be performed by qualified electrical technicians only.

Ensure the main power switch is turned [OFF] and locked at all times when performing maintenance procedures considered dangerous if the power is ON.

When working inside the machine, the door must be open.

Provide clear warning that the machine is being maintained and operations cannot be performed.

Before performing maintenance and inspection procedures inside the electrical cabinet or on motors, transformers or machine lighting, confirm the plant side power supply (circuit breaker) is turned OFF.

Maintenance procedures undertaken with the power turned ON must be performed by qualified electrical engineers.

Do not open electrical cabinet doors or the operation panel except to perform maintenance and inspection procedures.

Do not touch the hydraulic unit, coolant pump, solenoid valves and servomotors during, or immediately after operation as external surfaces reach high temperature.

Run this procedure