Bobcat Loader T76 T4

Replaced the hydraulic main and charge filters?

Replaced the Hydraulic fluid and Hydraulic reservoir vent filter?

Replaced the fluid of Final Drive Transmissions (Chaincases)?

Cleaned the heater coil and air conditioning evaporator? Cleaned the plenum drain?

Replaced fuel pre-filter element and fuel tank vent filter of Fuel System?

Replaced engine oil and filter element every 750 Hours or every 12 months?

Replaced the Coolant every 1500 Hours or every 24 months?

Sign off on the loader maintenance

Engine Air Filter display check

Check for leaks and damaged components

Sign off on the filters display check

NOTE: The following steps are done before starting the loader.

Check level of Engine Oil and add as needed

Check for loose connections and damaged components of Engine Air Intake Ducting

Clean Engine Cooling System. Clean debris from radiator cooling package, air conditioning condenser (if equipped), rear grilles, and engine compartment

Check coolant level COLD and add premixed coolant as needed

Sign off on the 10 Hours Engine Maintenance

Warning: This check should be performed every 10 hours or daily for the first 30 hours, then as scheduled.

Enter the torque after tightening the wheel nuts

Check condition of Accessory Drive Belt (Alternator, air conditioning, water pump). Replace as needed

Check the function of the lift arm bypass control in Bobcat Interlock Control System (BICS)

Check cables of Battery and connections