AXXAIR Closed Orbital TIG Welding Head SATFX-115-CA01

Ensure machine is powered down (main power disconnected)

Disassemble and Clean Welding Head

Completely disassemble the welding head

Perform a complete cleaning of the transmission, from the motor to the rotor

Remove all traces of grease or other debris

Check the integrity of the pinions

Check the toothing for irregular wear, burrs, or sharp edges

Check the pinion fixings for play (axial and radial)

Ensure the machine is live and operating

Perform a complete rotation of the welding machine rotor from the generator screen

Perform a complete rotation of the welding machine rotor from the buttons on the welding head

Check for any abnormal noise during operation

Did any abnormal noise occur during operation?

Ensure the workbench is clean and flat

Cut off the general power supply of the machine

Disconnect the welding generator unit

Ensure the following tool is available

Remove the two fixing screws from the spring clips using the 2.0mm BTR wrench

Remove the used or damaged welding glass

Switch off the machine (disconnect the main power supply)

Brush or rag clean the entire welding cable

Check that no hose is bent, pinched, worn, or shows any signs of tearing, or herniation

Check for leaks (coolant or gas) or noise that may reveal a leak

Check that all connections are tight

Ensure the workbench is clean and flat

Cut off the general power supply of the machine

Disconnect the welding generator unit

Remove coolant connection and secure the 2 caps

Ensure the 4 red seals are not lost and left in place