Trane CenTraVac™ Water-Cooled Chiller CVHF - 350-910 - 957 - 080S / 080S

- Check the chiller’s evaporator and condenser pressures, oil tank pressure, differential oil pressure, and discharge oil pressure

- Compare the readings with the values provided in the general maintenance

- Check the oil level in the chiller oil sump using the two sight glasses provided in the oil sump head. When the unit is operating, the oil level should be visible in the lower sight glass

- Complete logs on a daily basis.

- Shut down the chiller once each year to check the items for Leak Test Chiller

1. Check purge times and unit performance logs. If warranted, pressure leak test

2. Review oil analysis. If required, submit refrigerant sample for analysis

3. Inspect unit for any signs of refrigerant or oil leakage

4. Check unit for any loose screws on flange, volutes, or casing

Failure to follow safe leak test procedures below could result in death or serious injury or equipment or property-only-damage

Never use an open flame to detect gas leaks. Use a leak test solution for leak testing

- Lubricate the gantries annually

1. Use ConocoPhillips Gantries MegaPlex® XD3 (gray in color), LPS® MultiPlex Multi-Purpose (blue in color), or equivalent

- Lubricate the hinges annually

1. Use ConocoPhillips MegaPlex® XD3 (gray in color), LPS® MultiPlex Multi- Purpose (blue in color), or equivalent;

- Contact a qualified service organization to determine when to conduct a complete examination of the unit to discern the condition of the compressor and internal components

1. Check the following: chronic air leaks (which can cause acidic conditions in the compressor oil and result in premature bearing wear) 2. Check evaporator water tube leaks (water mixed with the compressor oil can result in bearing pitting, corrosion, or excessive wear)

3. Check condenser water tube leaks (water mixed with the compressor oil can result in bearing pitting, corrosion, or excessive wear);

- For R-123 chillers, perform the annual maintenance procedures referred to in Operation and Maintenance Guide: EarthWise Purge System with Tracer AdaptiView Control for Water-Cooled CenTraVac Chillers with R-123 Refrigerant (PRGF- SVX01*-EN). For R-514A chillers, perform the annual maintenance procedures referred to in Operation and Maintenance Guide: Purge System with Tracer AdaptiView Control for Water-Cooled CenTraVac Chillers with R-514A Refrigerant (PRGG-SVX001*-EN)

- Use an ice water bath to verify the accuracy of the evaporator refrigerant temperature sensor (4R10). If the sensor is exposed to temperature extremes outside its normal operating range (0°F to 90°F [-17.8°C to 32.2°C]), check its accuracy at six-month intervals

- Inspect the condenser tubes for fouling; clean if necessary

- Inspect and clean the ifm efector® flow detection sensors. Use Scotch-Brite® or other non-abrasive material to clean scale; do NOT use steel wool, which could cause the probe to rust

- Submit a sample of the compressor oil to a Trane- qualified laboratory for comprehensive analysis

- Measure the compressor motor winding resistance to ground; a qualified service technician should conduct this check to ensure that the findings are properly interpreted. Contact a qualified service organization to leak-test the chiller; this procedure is especially important if the system requires frequent purging;