Reznor Reznor Heater EXUB-10-AK2-BAX1-B EXUB-10-AK2-BAX1-B

Need answers fast?
Explore the manual using AI.

View PDF Manual

Explore Maintenance Plans

The Reznor Heater EXUB-10-AK2-BAX1-B is a robust industrial heating solution designed for efficient performance in various environments. This model ensures reliable heating with advanced safety features, making it ideal for commercial and industrial applications. Experience optimal comfort and efficiency with Reznor's trusted technology.

Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant

PDF MANUAL

Manual for Reznor Reznor Heater EXUB-10-AK2-BAX1-B EXUB-10-AK2-BAX1-B

MAINTENANCE RESOURCES

Complete asset maintenance, one click away

Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Reznor Reznor Heater EXUB-10-AK2-BAX1-B EXUB-10-AK2-BAX1-B

Create an account to install this asset package.

Maintenance Plans for Reznor Reznor Heater EXUB-10-AK2-BAX1-B Model EXUB-10-AK2-BAX1-B

Integrate maintenance plans directly into your work orders in MaintainX.

Yearly Inspection

- Check all terminal connections and electrical conductors for damage, looseness, defects, fraying, etc., and replace or tighten where applicable.

- Inspect contactor contacts. If badly pitted, burned or welded shut, replace with factory-supplied contactor. It is recommended that the contactor be replaced every two (2) years.

- Inspect thermal delay fuses. Fuse rating and type are printed on circuit board. Correct fuse must be in the ""ACTIVE"" fuse clip. An extra fuse should be stored in the clips marked ""SPARE"".

- Check for fluid leakage from heat-exchanger.

- Check all explosion-proof conduit and fittings. Replace damaged components. All threaded conduit connections must have a minimum of 5 turns of engagement. Taper threaded connections must be at least hand-tight. Inside of enclosures must be clean, dry, and free from any foreign materials. Enclosure covers must also be completely on and tight.

- Check electrical resistance on all load side legs. Reading should be balanced (± 5%).

- Check motor shaft bearing play. Replace motor if play is excessive or if motor does not run quietly and smoothly. Motor bearings are permanently lubricated.

- Check fan blade. Replace immediately if cracked or damaged.

- Check louvers. Louver screws should be tight. Louvers must not be set less than 30 degrees of the closed position.

Run this procedure