Nidec Multifunction Edger ME-1000

Warning: Do not mix antifoam agents with the processing water.

When “Please clean tank & pump” appears and the processing is stopped, replace the processing water and stocking filter, and remove the waste accumulated in the drain pipe connector.

Take the tank out of the cabinet.

Disconnect the two feedwater hoses.

Disconnect the drain pipe from the tank.

Drop the stocking filter into the tank.

Remove the cover of the tank and put the waste in the stocking filter into the tank.

Filter the processing water to separate the processing waste and water.

Dispose of the waste in the tank, following local governing ordinances.

Warning: Follow the steps carefully to avoid damage to the equipment.

Take the tank out of the cabinet.

Disconnect the two feedwater hoses.

Disconnect the drain pipe from the tank.

Drop the stocking filter into the tank.

Remove the cover from the tank.

Remove the layer at the top from the tank.

Dispose of the waste in the tank, following local governing ordinances.

Put the water into the tank up to the position illustrated in the figure on the right.

Check visually that the processing wheels are not cracked.

Confirm that wash water (for the inside wall of the processing chamber) and cooling water (for the wheels) flow properly.

CAUTION! Take care not to get spray into your eyes. Spray including processing waster may damage your eyes.

Is the processing chamber cleaned?

Is there any dirt or damage on the edger?

Check that there is no deterioration in the processing performance.

Replace the wheel if the processing surface is frayed, which will be a problem in practical use.

Apply more grease to the waterproof seal.

Replace the waterproof seal if it is deteriorated.

Check that the chamber has no problems such as cracks, fractures or deterioration.

Replace the chamber if there is a problem.

Replace the wheel rotation belt

Apply more grease to the waterproof seal

Check that the processing performance of the safety beveling wheel is not deteriorated

Replace the wheel if the processing surface is frayed