MacNeil Wash Systems Tunnel Equipment Tunnel Equipment

Clean lenses and check alignment. (both sides)

Upload a photo of the cleaned lenses

Hose down all grit from conveyor and floor area

Verify room heater working during cold weather

Verify high pressure pump oil level is visible in sight gauge

Verify air compressor pressure is above 90 psi

Check for water, oil or chemical leaks. Listen for air leaks

Drain water from air compressor tank & all separator bowls

Check chemical levels. Fill & re-order as needed

Check chemical lines for air bubbles, there should be solid chemical from tank to pump

Sign off on the daily maintenance

Program a best wash and run wash

Verify all foamers and nozzles spray correctly

Verify proper equipment sequence and operation

Check all wash components for proper operation and timing

Verify exit traffic light & wind curtain operation (cold weather sites)

Check cleanliness & dryness of vehicle

Note: Wind curtains should be open for summer operation

Sign off on the daily maintenance of the test car

Push Emergency Stop Button (E-Stop) to disable car wash

Verify tunnel heaters working during cold weather

Check conveyor for foreign objects or ice build-up especially at entrance and exit ends

Check for air, chemical, water leaks

Check all cleaning material for foreign objects or excess wear

Check blower intake screens for foreign objects

Check conveyor trench for water build up

Remove any foreign objects from floor. Hose down tunnel walls and floor.

Pull Emergency Stop Button to re-enable the car wash