Lincoln Electric Welder RED-D-ARC GX 271

- At the end of each day’s use, refill the fuel tank to minimize moisture condensation in the tank. Running out of fuel tends to draw dirt into the fuel system. Also, check the crankcase oil level and add oil if indicated;

- Store the GX-271 in clean, dry protected areas

- Blow out the generator and controls periodically with low pressure air. Do this at least once a week in particularly dirty areas

- It is normal for the brushes and slip rings to wear and darken slightly. Inspect the brushes when a generator overhaul is necessary;

- Keep the battery clean by wiping it with a damp cloth when dirty. If the terminals appear corroded, disconnect the battery cables and wash the terminals with an ammonia solution or a solution of 1/4 pound (0.1113 kg) of baking soda and 1 quart (0.946 L) of water. Be sure the battery vent plugs (if equipped) are tight so that none of the solution enters the cells

- After cleaning, flush the outside of the battery, the battery compartment, and surrounding areas with clear water. Coat the battery terminals lightly with petroleum jelly or a non-conductive grease to retard corrosion

- Keep the battery clean and dry. Moisture accumulation on the battery can lead to more rapid discharge and early battery failure

- If battery cells are low, fill them to the neck of the filler hole with distilled water and recharge. If one cell is low, check for leaks

- When you charge, jump, replace, or otherwise connect battery cables to the battery, be sure the polarity is correct. Improper polarity can damage the charging circuit. The GX-271 positive (+) battery terminal has a red terminal cover

- If you need to charge the battery with an external charger, disconnect the negative cable first, then the positive cable before you attach the charger leads. after the battery is charged, reconnect the positive battery cable first and the negative cable last. Failure to do co can result in damage to the internal charger components;