Hussmann Q-Series Medium Temperature Self Contained Merchandiser Q2SSM2S

Warning: Always wear gloves and protective eye wear when cleaning near sharp coil fins and dust particles.

Check if condenser coils are clean

If coils are dirty, proceed with the following steps

Use a vacuum cleaner with a wand attachment to clean the coils

Use a soft (non-metallic) brush to remove dirt and debris

Ensure coil fins are not bent during the cleaning process

Long life and satisfactory performance of any equipment is dependent upon the care it receives. To ensure long life, proper sanitation and minimum maintenance costs, these merchandisers should be thoroughly cleaned, all debris removed and the interiors washed down, weekly.

Exterior surfaces cleaned with a mild detergent and warm water

Interior surfaces cleaned with appropriate cleaners

Check if any of the following were used

WARNING! Product will be degraded and may spoil if allowed to sit in a non-refrigerated area.

Record any complaints or issues the store manager has with the unit

Check unit for any damage, vibrations or abnormal noise

Verify unit is level side to side and front to rear

Confirm refrigerant lines are properly secured and not touching or rubbing other lines, wires or framework

Verify fan motors and motor mounts are tight

Confirm fan blades are tight and not rubbing or hitting

Make sure all electrical connections, factory and field, are tight

Verify electrical connections at lamps are secure and dry

Check for and replace any frayed or chaffed wiring

Warning: Be careful not to damage the louvers during cleaning

Choose the cleaning method used

Is all water removed from the louvers cells before replacing?

Are the louvers damaged during cleaning?

Sign off on the louver cleaning

Clean evaporator coil/s and fan blade/s. Do not use an acid base cleaner. Rinse off any cleaner residue.

Clean discharge air honeycombs or grilles. Do not use an acid base cleaner. Rinse off any cleaner residue.

Clean condenser coil/s and fan blade/s. Do not use an acid base Cleaner. Rinse off any cleaner residue.

Clean condensate drain pan and drain line.

Verify condensate drain lines are clear and functioning.

Record voltage reading at unit with unit off.

Record voltage reading with unit running.

Record defrost heater voltage and amp draw.