Honeywell Honeywell Adapter OWA 100 OWA 100

- Replace Battery, if the adapter shows a "Low Battery" message

1. Loosen (4) M4 screws and remove the cover

3. Remove the old battery from the battery holder. If needed, pry out the battery by using a slotted screwdriver as a lever

5. Install battery as follows to avoid snagging the battery terminal on the clip and damaging the battery

Align the new battery with the clips and angle the positive (+) end of the batteryinto the positive (+) battery terminal clip. Using a thumb and forefinger pull the negative terminal clip outward and push down on the battery until fully seated in both clips. Do not apply excessive force when pushing the battery down

6. Replace the cover and tighten the (4) M4 screws with a torque of 1.0 N.m / 9.0 lbf-inch

7. Dispose the used battery promptly per local regulations or the battery manufacturer's recommendations. Keep away from children. Do not disassemble and do not dispose of in fire;