Hammer Strength Hammer Strength Plate-Loaded PL-LE

Fill in paint chips with manufacturers touch-up paint

Visually inspect all hardware for loosening, tampering or wear

Clean Hand grips with an approved or compatible cleaner

Sign off on the machine maintenance

Washed the unit with approved or compatible cleaners using a clean sponge or a soft cloth?

Dried thoroughly with a chamois or moist cellulose sponge to prevent water spots?

Removed fresh paint splashes, grease and smeared glazing compounds before drying by rubbing lightly with isopropyl alcohol?

Made a warm final wash, beginning with a mild soap or detergent solution and ending with a thorough rinsing with clean water?

HAMMER STRENGTH APPROVED CLEANERS

Used PureGreen 24 or Gym Wipes to remove dirt, grime and sweat from equipment?

Applied the spray to a microfiber cloth and wiped down the equipment?

Inspect frames for wear and damage

Inspect hand grips for wear and damage

Inspect all accessories, connecting links, and carabiner clips for wear

Check for belt stretch on PLBI and adjust as necessary by loosening the belt clamp on top of the lower movement arm, then pulling loose end of belt to tighten. Tighten belt clamp down

Sign off on the weekly strength training machine maintenance

1. Clean Upholstery with an approved or compatible cleaner.

Wipe down upholstery with a mild soap and water or comparable all purpose cleaner.

2. Inspect Belts. Look for wear or damage and proper tension. Pay close attention at bends and attachment points.

Visually inspect belts for wear at and around connections and along the entire length of the belt. Always replace at first sign of wear.