Epson Multimedia Projector 1970W

Caution: Use only the type of batteries specified in this manual. Do not install batteries of different types, or mix new and old batteries.

Open the battery cover as shown.

Warning: If the battery fluid has leaked, wipe it away with a soft cloth and avoid getting the fluid on your hands. If it gets on your hands, wash them immediately to avoid injury.

Insert the batteries with the + and – ends facing as shown.

Close the battery cover and press it down until it clicks into place.

Warning: Dispose of used batteries according to local regulations. Do not expose batteries to heat or flame. Keep batteries out of the reach of children; they are choking hazards and are very dangerous if swallowed.

Sign off on the battery replacement

Select the Reset menu and press Enter

Select Reset Lamp Hours and press Enter

You see a prompt asking if you want to reset the lamp hours

Press Menu or Esc to exit the menus

Sign off on the lamp timer resetting

Warning: Let the lamp fully cool before replacing it to avoid injury.

Projector turned off and power cord unplugged

Projector lamp cooled down for at least one hour

Screw securing the lamp cover loosened

Warning: If the lamp is broken, glass fragments may be loose inside the lamp chamber. Be careful removing any broken glass to avoid injury.

Lamp cover slid out and lifted off

Screws securing the lamp to the projector loosened

Old lamp gently pulled out of the projector

Note: The lamp(s) in this product contain mercury. Please consult your state and local regulations regarding disposal or recycling. Do not put in the trash.

Warning: Before cleaning any part of the projector, turn it off and unplug the power cord. Never open any cover on the projector, except as specifically explained in this manual. Dangerous electrical voltages in the projector can injure you severely. Do not try to service this product yourself, except as specifically explained in this manual. Refer all other servicing to qualified servicers.

Projector turned off and power cord unplugged

To remove dust or dirt, use a soft, dry, lint-free cloth.

To remove stubborn dirt, use a soft cloth moistened with water and mild soap. Do not spray liquid directly on the projector.

Caution: Do not use wax, alcohol, benzene, paint thinner, or other chemicals to clean the projector case. These can damage the case. Do not use canned air, or the gases may leave a residue.

Projector case cleaned without using harmful chemicals

Sign off on the projector case cleaning

You need to replace the air filter in the following situations:

• After cleaning the air filter, you see a message telling you to clean or replace it

• The air filter is torn or damaged

You can replace the air filter while the projector is mounted to the ceiling or placed on a table.

1. Turn off the projector and unplug the power cord.

2. Slide the air filter cover latch and open the air filter cover.

3. Pull the air filter out of the projector.

Note: Air filters contain polypropylene. Dispose of used air filters according to local regulations.

4. Place the new air filter in the projector as shown and push gently until it clicks into place.