Endress+Hauser Cerabar PMP71-ANA1SE2GAABA

WARNING! Incorrect repair can compromise electrical safety! Explosion hazard!

Repairs to Ex-certified devices must be carried out by Endress+Hauser Service or by specialist personnel according to national regulations.

Relevant standards, national hazardous area regulations and Safety Instructions and Certificates must be observed.

Only genuine Endress+Hauser spare parts may be used.

When ordering spare parts, please check the device designation on the nameplate. Only replace parts with identical parts.

Electronic inserts or sensors already in use in a standard instrument may not be used as spare parts for a certified device.

Carry out repairs according to the instructions. After repairs, the device must fulfill the requirements of the specified individual tests.

A certified device may only be converted into another certified variant by Endress+Hauser.

Did you use only genuine Endress+Hauser spare parts?

- Keep the pressure compensation and GORE-TEX® filter (1) free from contamination and water.

- Endress+Hauser provides flushing rings as an accessory to enable cleaning of the process membrane without removing the transmitter from the process. For further information, please contact your local Endress+Hauser Sales Center.

Please note the following points when cleaning the measuring instrument:

- The cleaning agents used should not corrode the surface and the seals.

- Mechanical damage to the process membrane, e.g. due to pointed objects, must be avoided.

- Observe the degree of protection of the device. See the nameplate if necessary.;