Daikin Rooftop Unit MPSA05

Warning: This procedure requires trained personnel with PPE!

Reference Figure 44 for location of the speed tap block on the blower

Remove the furnace control access panel

See Figure 45 for location of the integrated furnace control board

Reference Figure 44 and Figure 46 for the proper location of the red and black wires on the speed tap block and on the furnace integrated control board to obtain the speed tap you have chosen

After adjusting the wires accordingly, attach the control box cover, furnace control access panel and the blower access panel to the unit

Sign off on the blower motor speed change

DANGER: Power supply to unit must be disconnected before making field connections

To avoid electrical shock, personal injury or death, be sure to rigorously adhere to field wiring procedures regarding proper lockout and tagout of components

It is recommended that at the beginning of each cooling season a qualified installer or service agency inspect and clean the cooling section of this unit

The following areas should be addressed

DANGER: Label all wires prior to disconnection when servicing the unit

Wiring errors can cause improper and dangerous operation resulting in fire, electrical shock, property damage, severe personal injury or death

Remove the filter access panel and the blower/evaporator coil access panel. Remove the filters

Shine a flashlight on the evaporator coil (both sides) and inspect for accumulation of lint, insulation, etc.

Power supply to unit must be disconnected before making field connections

To avoid electrical shock, personal injury or death, be sure to rigorously adhere to field wiring procedures regarding proper lockout and tagout of components

Holes in the exhaust transition or heat exchanger can cause toxic fumes to enter the building

The exhaust transition or heat exchanger must be replaced if they have holes or cracks in them

Failure to do so can cause carbon monoxide poisoning resulting in personal injury or death

Warning: This procedure requires trained personnel with PPE!

Supply and manifold pressure taps are located on the gas valve body 1/8\ N.P.T. and on the manifold"

Use a properly calibrated manometer gauge for accurate gas pressure readings

Only small variations in the gas flow should be made by means of the pressure regulator adjustment

Furnaces functioning on LP gas must be set by means of the tank or branch supply regulators

Note: The blower motor and induced draft blower motor are prelubricated by the manufacturer and do not require further attention.

A qualified installer, service agency or the gas supplier must periodically clean the motors to prevent the possibility of overheating due to an accumulation of dust and dirt on the windings or on the motor exterior.

The motor depends upon sufficient air flowing across and through it to prevent overheating.

Is there sufficient air flow across and through the motor?

Sign off on the motor maintenance