Daikin Packaged Rooftop System DPS012AHMY4DW-4

Warning: This maintenance requires trained and experienced service technician

Warning: Fuel pressure settings and control settings should be made only by persons thoroughly experienced with the burner and control system

Warning: Always replace covers on burner controls and boxes as the electrical contacts are sensitive to dust and dirt

Warning: Installation and maintenance must be performed only by qualified personnel who are experienced with this type of equipment and familiar with local codes and regulations

Notice: Gas or Hot Water Piping: A qualified Architect or Systems HVAC Design Engineer familiar with piping design, local codes and regulations, must provide piping design

Danger: Moving machinery and electrical power hazards. May cause severe personal injury or death. Disconnect and lock off all power before servicing equipment

Warning: Sharp edges are inherent to sheet metal parts, screws, clips, and similar items. May cause personal injury

Servicing Control Panel Components: Disconnect all electric power to the unit when servicing control panel components

Danger: Hazardous voltage. May cause severe injury or death. Disconnect electric power before servicing equipment

Select filter size for 003–006 cabinet

Select filter size for 003–006 with ERW cabinet

Select filter size for 007–015 cabinet

Select filter size for 007–015 with ERW cabinet

Select filter size for 007–015 with CORE cabinet

Select filter size for 016–028 cabinet

Select filter size for 016–028 with ERW cabinet

Select filter size for 016–028 with CORE cabinet

WARNING: Prior to cleaning the unit, turn off and lock out the main power switch to the unit and open all access panels

The following cleaning procedures are recommended as part of the routine maintenance activities for Option E Coated Coils. Documented routine cleaning of Option E Coated Coils is required to maintain warranty coverage.

1. Remove Surface Loaded Fibers: Surface loaded fibers or dirt should be removed prior to water rinse to prevent further restriction of airflow.

If unable to back wash the side of the coil opposite that of the coils entering air side, then surface loaded fibers or dirt should be removed with:

NOTE: Use of a water stream, such as a garden hose, against a surface loaded coil will drive the fibers and dirt into the coil. This will make cleaning efforts more difficult. Surface loaded fibers must be completely removed prior to using low velocity clean water rinse.

2. Periodic Clean Water Rinse: A monthly clean water rinse is recommended for coils that are applied in coastal or industrial environments to help to remove chlorides, dirt and debris.

An elevated water temperature (not to exceed 130°F) will reduce surface tension, increasing the ability to remove chlorides and dirt.

Pressure washer PSI must not exceed 900 psig and the nozzle should remain at least 1 foot from the coil to avoid damaging fin edges.

Sign off on the monthly coated coil cleaning

Check all moving parts for wear every six months

The Rebel exhaust fans are direct drive variable speed fan/motor combination, which do not have belts or pulleys to maintain

The bearings are permanently sealed and do not require periodic greasing. The Rebel 3-15 ton units have similar supply fans.

The Rebel 16-28 tons supply fans have a direct drive motor

These larger motors are not permanently sealed and will require greasing every 9000 hours

CAUTION: Severe loss of charge may occur if the high refrigerant pressure switch is replaced before reclaiming the refrigerant. Replace pressure switch after reclaiming refrigerant

DANGER: Hazardous voltage. May cause severe injury or death. Disconnect electric power before servicing equipment. More than one disconnect may be required to de-energize the unit

Service Refrigerant Sensors or Switches

Service Optional Electric Heater

Measure continuity through all fuses

Check that all electrical connections are tight. Look for signs of arcing

Check the resistance to ground for each circuit. It should be infinite

Check the resistance phase to phase for each circuit