Caterpillar Mini Hydraulic Excavator 310

Clean the battery surface with a clean cloth

Keep the terminals clean and coated with petroleum jelly

Install the post cover after coating the terminal post with petroleum jelly

Tighten the hold-downs for the battery to prevent movement during machine operation

Open the engine access door and remove the fan guard

Loosen mounting bolt and adjusting bolt

Move alternator and remove the old belt. Replace with a new belt

Adjust the belt tension by moving alternator

Note: Refer to Special Publication, SEBU6250, “Caterpillar Machine Fluids Recommendations” for more information on grease.

1. Wipe the fittings before lubricating the swing bearings.

Note: There are two fittings that need lubricant. One fitting is on the front of the swing bearing and one fitting is on the rear of the swing bearing.

2. Apply lubricant through both fittings until the lubricant comes out of the bearing (area (1) below the fitting).

3. Rotate the upper structure of the machine 90 degrees from the original position.

Note: The grease fitting rotates with the upper machine structure.

4. Apply lubricant through both fittings until the lubricant comes out of the bearing (area (1) below the fitting).

5. Repeat Step 3 and Step 4 until the upper structure has rotated 360 degrees.

Boom and Stick Linkage - Lubricate

Boom and Stick Linkage - Lubricate

Air Cleaner Dust Valve - Clean/Inspect

Air Conditioner/Cab Heater Filter (Recirculation) - Inspect/Replace

Cab Air Filter (Fresh Air) - Clean/Replace

Cooling System Coolant Level - Check

Engine Air Filter Service Indicator - Inspect

WARNING: Engine hood and engine hood parts can be hot while engine is running or immediately after engine shutdown. Hot parts or hot components can cause burns or personal injury. Do not allow these parts to contact your skin, when engine is running or immediately after engine shutdown.

WARNING: Personal injury can result from hot coolant, steam and alkali.

NOTICE: Do not change the coolant until you read and understand the cooling system information in Special Publication, SEBU6250, “Caterpillar Machine Fluids Recommendations”.

NOTICE: Mixing ELC with other products will reduce the effectiveness of the coolant.

Gain access to the radiator cap by opening access cover (1).

Make sure that the cooling system has cooled down. Loosen the cooling system pressure cap (3) slowly to relieve system pressure.

Inspect the gasket on the pressure cap. If the gasket is damaged, replace the pressure cap.

Open the rear access door on the right side of the machine.

Engine Crankcase Breather - Replace

Open the engine access door at the rear of the machine. Refer to Operation and Maintenance Manual, “Access Doors and Covers”.

The engine crankcase breather is located in the engine compartment on the right-hand side of engine. A replaceable filter element is located inside the engine crankcase breather.

Remove cover (4) and remove filter element (2).

Clean housing (1) and cover (4).

Inspect O-ring for damage. Replace if necessary.

Install a new filter element and Install cover (4).

Sign off on the maintenance procedure