Boss Snowplow Plows MSC24994

• Apply dielectric grease to the wire-harness connectors.;

- 1. Park the vehicle on a level surface, lower the plow, turn off the vehicle, and remove the keys.

- 2. Clean the area around the hydraulic drain plug (Figure 47).

- 3. Place a drain pan under the plug and remove the plug.

- 5. Allow the fluid to fully drain, then replace the plug. Torque the plug to 17 to 28 N∙m (150 to 250 in-lb).;

• Check the hydraulic cylinders.

• Check the hydraulic-fluid level.

• Check the hydraulic lines and hoses.

• Check the torque of all fasteners, pins, retainers, nuts, and bolts.

• Check the wire-harness connector.;