Bobcat Loader S250

Remove trapped water in fuel filter

Lubricate Bob-Tach Pivot & Wedges

Lubricate Steering Cylinders (Aws Machines Only)

Check function of Seat Belt, Seat Bar And Control Interlocks

Clean dirt and debris from moving parts of Seat Belt, Seat Bar And Control Interlocks

Check for correct function of BISC

Hydraulic system filter replaced?

Hydrostatic system filter replaced?

Reservoir breather cap replaced?

Steering Valve Inline Filter replaced (Aws Only)?

Oil in Hydrostatic Motor Carrier replaced (Track Machines Only)?

Sign off on the 500 Hours Loader Maintenance

NOTE: The following steps are to be performed before starting the loader.

If not, add as needed. Do not overfill. Change oil and filter after first 50 Hrs.

Engine air filter indicator and/or display in good condition?

Service only when required. Do not use compressed air to clean elements.

Any leaks or damaged components in the engine air system?

If yes, report to maintenance team.

Is the grill, oil cooler and radiator of engine cooling system clean from debris?

Empty spark chamber. (If equipped Spark Arrestor Muffler.)

Check battery for damage, hold down clamps, cables, connections and electrolyte level. Add distilled water as needed

Lubricate drive line Engine-to-Pump Coupler with multipurpose lithium based grease. (If equipped.)

Sign off on the loader maintenance

Replaced fluid on Hydraulic Reservoir

Replaced fluid on Final Drive Transmission (Chaincase On Wheel Machines Only)

Replaced fluid (If required) in Track Roller, Idler Assemblies (Track Machines Only)

Replaced Drive Motor Case Drain Filter (If equipped)

Repacked wheel bearings, greased internal splines in hub yoke. (Dealer Service Only) Wheel Bearing & Outer Splines (Aws Only)

Sign off on the 1000 Hours Loader Maintenance