The Atlas Copco Oil-Sealed Rotary Vane Vacuum Pump GVS 470A is designed for efficient vacuum generation in industrial applications. Known for its reliability and performance, this model is ideal for various processes requiring consistent vacuum levels. Optimize your operations with this high-quality vacuum pump from a trusted OEM.

Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant

MAINTENANCE RESOURCES

Complete asset maintenance, one click away

Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Atlas Copco Oil-Sealed Rotary Vane Vacuum Pump GVS 470A

Create an account to install this asset package.

Maintenance Plans for Atlas Copco Oil-Sealed Rotary Vane Vacuum Pump Model GVS 470A

Integrate maintenance plans directly into your work orders in MaintainX.

1000 Hourly Mineral Oil Change

Warning: Ensure the pump is cold before starting the procedure

Run the pump with closed suction intake for 10 minutes to warm up the oil

Stop the pump and disconnect it from the mains

Remove the oil filler plug

Open the oil drain valve and drain the oil completely into a container large enough to hold all the oil and tilt the pump slightly (if possible)

Close the oil drain valve and fill with new oil through the filler plug up to the middle of the oil sight glass. The oil level must not exceed the allowed maximum level

Close the oil filler plug

Wipe off eventual oil spills from the pump and/or the floor

Connect to mains again and verify correct rotation direction of the pump

Run this procedure

1000 Hourly Mineral Oil Filter Change

Drain the used oil completely

Remove the oil filter

Apply a thin film of oil on the gasket of the new oil filter

Clean carefully the contact surface of the gasket on the tank

Install the new oil filter

Fill with new oil

Sign off on the oil filter change

Run this procedure

1000 Hourly Synthetic Oil Change

Is the pump cold?

If the pump is cold, run the pump with closed suction intake for 10 minutes to warm up the oil.

Stop the pump and disconnect it from the mains.

Remove the oil filler plug.

Open the oil drain valve and drain the oil completely into a container large enough to hold all the oil and tilt the pump slightly (if possible).

Close the oil drain valve and fill with new oil through the filler plug up to the middle of the oil sight glass. The oil level must not exceed the allowed maximum level.

Close the oil filler plug.

Wipe off eventual oil spills from the pump and/or the floor.

Connect to mains again and verify correct rotation direction of the pump.

Run this procedure

1000 Hourly Synthetic Oil Filter Change

Drain the used oil completely

Remove the oil filter

Apply a thin film of oil on the gasket of the new oil filter

Clean carefully the contact surface of the gasket on the tank

Install the new oil filter

Fill with new oil

Sign off on the oil filter change