Atlas Copco Oil-Injected Screw Compressor GA7VSDS FF

Check that condensate is discharged by the dryer drain by waiting for some time during operation

You can use the test button on top of the electronic water drain to check the drain function

Sign off on the daily oil-injected screw compressor check

WARNING! Do not use water or solvents to clean the condenser

Compressor stopped, air outlet valve closed and voltage switched off

Upload a photo of the condenser inlet before cleaning

Dirt on the condenser inlet removed with a vacuum cleaner

Condenser cleaned with an air jet in the reverse direction to normal flow

Low pressure air used for cleaning

Compressed air nozzle kept more than 30 cm away from the condenser

Upload a photo of the condenser after cleaning

Dust from inside the dryer removed with a vacuum cleaner

Front service panel removed with the key delivered with the compressor

RH sensor disconnected and removed from the panel by loosening the bolt

Cleaning solution used for RH sensor

RH sensor cleaned and let to dry

RH sensor refitted and reconnected

Sign off on the sensor cleaning

Replace Smart Temperature Control (STC) valve

NOTE! For compressor elements used on operating pressures below or equal to 10 bar (145 psi), the service can be postponed to 32000 running hours;

Cover all parts underneath the cooler

Remove the service plate at the fan compartment

Remove dirt from the coolers with a fiber brush. Brush in the direction of the cooling fins

Remove dirt from the fan with a fiber brush