Atlas Copco Oil Injected Rotary Screw Compressor G2FF

Stop the compressor, close the air outlet valve and switch off the voltage

For Full-Feature versions: also stop the dryer

Remove the front panel of the compressor housing

Remove the side, back and top panels of the compressor housing

Adjust the belt tension by turning tensioning nut

The tension is correct when a force of 50 N (11.25 lbf) applied at the midpoint of the belt causes a deflection of 6 mm (0.23 in)

Warning: Ensure the compressor is stopped and the voltage is switched off before starting the cleaning process.

Compressor stopped and air outlet valve closed?

Dirt removed from the cooler with a fibre brush?

Did you use a wire brush or metal objects?

Warning: Never use a wire brush or metal objects for cleaning.

Sign off on the cooler cleaning

Drain the condensate from the air receiver after stopping

Apply manual drain valve for drain condensation

Drain condensate from the oil separator vessel every 50 Hours / 1 Week

Check the belt tension after 50 running hours

Is filter replacement necessary?

Sign off on the filter maintenance

Warning: This procedure requires trained personnel with PPE!

Enter the element outlet temperature

Was the fluid changed successfully?