Atlanta Attachment Company Automatic Decorative Border Workstation 1312

Safety Equipment on the Machines

All machines are delivered with safety equipment, which shall not be removed or bypassed during operation.

Is the safety equipment on the machine intact and not bypassed?

The correct functioning of safety equipment on machines and systems should be checked every day and before every new shift starts, after maintenance and repair work, when starting up for the first time and when restarting (e.g. after prolonged shutdowns).

Is the safety equipment functioning correctly?

If safety equipment has to be dismantled for setting-up, maintenance or repair work, such safety equipment shall be replaced and checked immediately upon completing the maintenance or repair work.

Has the safety equipment been replaced and checked after maintenance or repair work?

All protective mechanisms shall be fitted and fully operational whenever the machine is at a standstill or if it has been shut down for a longer period of time.

Are all protective mechanisms fitted and fully operational?

Warning: Follow the steps carefully to avoid damage to the tape

No chemicals or abrasives used for cleaning

Avoided contact with oils and liquids

Did not touch the tape with bare fingers

If tape is dirty or opaque, report to the maintenance team

Sign off on the reflective tape maintenance

The power supply must be switched off (master switch off) and secured so that it cannot be switched on again inadvertently before starting any work on live parts.

Those parts of the machine and plant on which inspection, maintenance or repair work is to be carried out must be isolated from the power supply, if specified. The isolated parts must first be checked to determine that they are truly de-energized before being grounded and short-circuited. Adjacent live parts must also be isolated.

The protective measures implemented (eg. grounding resistance) must be tested before restarting the machine after all assembly or repair work on electric parts.

Signal generators (limit switches) and other electrical parts on the safety mechanisms must not be removed or bypassed. Only use original fuses or circuit overloads with the specified current rating. The machine must be switched off immediately if a fault develops in the electrical power supply.

The electrical equipment of our machines must be checked at regular intervals and any defects found must be remedied immediately.

If it is necessary to carry out work on live parts, a second person should be on hand to operate the emergency OFF switch or master switch with voltage release in the event of an emergency. The working area should be cordoned off and marked by a warning sign. Only use electrically insulated tools.;

Machine switched off and secured

Machine cleaned from oil, grease, dirt and waste

All screw connections retightened

Safety mechanisms refitted and checked

Activities and intervals specified in the Instruction Manual observed

All hydraulic and pneumatic lines examined for leaks, loose connections, rubbing and damage