Arctic Snow & Ice Products Snow Pusher CD-6.5

Remove nuts and bolts to detach old cutting edge

Place bolts into recessed holes on the new cutting edge

Verify all bolts are flush against the cutting blade

Describe any issues encountered during replacement

Ensure the following tools are available

Is the wear shoe in a hanging position off the ground?

Is the pusher elevated a few inches to take pressure off mounting points?

Enter the number of nuts and washers to be removed (6 for CD and LD models, 7 for HD models)

Remove all nuts and washers attaching the shoe to the side panel

Check and replace any damaged parts

Ensure replacement cutting edges and polyblocks are available

Check all fasteners for looseness, including those on the angle iron (HD models) on the slip hitch mounts

Is the backside of the cutting edge wearing into the mounting plate?

Measure the height of the blade showing (in inches)

Does the blade height measure 1.5 inches or less?

Ensure you have the following tools

Remove nuts and bolts to free the polyblock being replaced.

Attach the new polyblock to moldboard using hex bolt, flat washer(A), and poly block washer(B). Start nuts to hold in place without fully tightening.

Secure opposite end of the polyblock on mainframe using flange bolts and poly block washer, then tighten all fasteners with 100 ft lbs. (lbf-ft) torque.

Ensure the thinner polyblock is on the top and the thicker one on the bottom.

Special Note Regarding Changes in Bottom Polyblocks

Note any signs of wear or premature breakage on bottom polyblocks.