ZF Padova Reduction Gearbox ZF 280 IV 3.094

Check for oil leaks and oil level

Measure oil level two minutes after turning off the engine

Is the oil level between the upper and lower marks on the dipstick?

Run the gearbox for about two minutes after initial filling or repairs

Recheck oil level two minutes after turning off the engine

Tighten all external threaded fasteners

Unplug the shift control linkage connecting cable with the control valve lever

Remove the filler cap and extract the oil level dipstick

Drain off the lubricant oil by removing the drain plugs, saving the gaskets

Collect the used oil and observe the binding rules for special waste disposal

Fill with oil through the filler cap and screw in the cap to torque

Check oil level two minutes after turning off the engine

Is the oil level between the upper and lower marks on the dipstick?

Run the gearbox for about two minutes after initial filling or repairs

Recheck the oil level two minutes after turning the engine off

Remove the filler cap and extract the oil level dipstick

Drain off the lubricant oil by removing the drain plugs, saving the gaskets

Collect the used oil and observe the binding rules for special waste disposal

Unplug the shift control linkage connecting cable from the control valve lever

Put the lever in the forward drive position

Select the forward direction with the bridge console control lever

Do the positions of the respective couplers (lever/cable) coincide?

Put the lever in the reverse drive position

Ensure towing duration does not exceed 8 hours

Is the control lever position irrelevant when the engine is off?

Record the oil temperature during towing

Is the oil temperature below 80°C during towing?

Avoid performing operations on the transmission during towing

Ensure the propeller does not start turning during towing