Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Zebra Printer R110Xi

Create an account to install this asset package.

Maintenance Plans for Zebra Printer Model R110Xi

Integrate maintenance plans directly into your work orders in MaintainX.

Black Mark Sensor Cleaning

Warning: Ensure the machine is turned off before starting the cleaning process

CLEAN HEAD NOW message appears?

Select the print mode

Air blow cleaning performed?

Sign off on the sensor cleaning

Run this procedure

Cutter Cleaning

Warning: The cutter blade is sharp. Do not touch or rub the blade with your fingers.

Turn off (O) the printer.

Unplug the power cord.

Clean the stationary cutter blade with a swab and solvent.

If cleaning does not remove label fragments and adhesive, contact an authorized service technician.

Sign off on the cutter cleaning

Run this procedure

Fuse Replacement

Warning: Turn the AC power switch off (O) and remove the power cord before performing this procedure.

The printer uses a metric-style fuse (5 × 20 mm IEC) rated at F5A, 250 V.

The AC power entry module comes with two approved fuses in the fuse holder: one is in-circuit, and the second is provided as a spare.

The end caps of the fuse must bear the certification mark of a known international safety organization.

Use a small-blade screwdriver or similar tool to remove the fuse holder.

Remove the faulty fuse and install a new fuse in the in-circuit position.

Important: If you use the spare fuse, be sure to order a replacement fuse from an authorized Zebra distributor. The spare fuse should be the exact type and rating as the original in-circuit fuse.

Snap the fuse holder back into the AC power entry module.

Reconnect the power cord, and turn the printer on (I).

Run this procedure

Media Path Cleaning

Warning: Use solvent for cleaning!

CLEAN HEAD NOW message appears?

Select the print mode

Enter the length of labels used in Direct Thermal Print Mode

Enter the length of ribbon used in Thermal Transfer Print Mode

Cleaning successful?

Sign off on the media path cleaning

Run this procedure

Platen Roller Cleaning

Warning: The printhead may be hot and can cause severe burns. Allow the printhead to cool.

Before touching the printhead assembly, discharge any built-up static electricity by touching the metal printer frame or by using an anti-static wriststrap and mat.

While performing any tasks near an open printhead, remove all rings, watches, hanging necklaces, identification badges, or other metallic objects that could touch the printhead.

Open the printhead assembly by rotating the printhead-open lever counter-clockwise.

Remove the media and ribbon.

Using the swab from the Preventive Maintenance Kit, wipe along the brown strip on the printhead assembly from end to end.

While manually rotating the platen roller, clean it thoroughly with the swab.

Reload the media and the ribbon.

Push down the printhead assembly, and then rotate the printhead-open lever clockwise until it locks into place.

Run this procedure