Skyjack Telehandler SJ1044 TH

Red band appears on the service indicator

Air cleaner vaccuator valve is clean and rubber is not cracked

Valve lips are free of dirt or dust

Engine expels dust and dirt continuously when running

Condition of primary and safety elements inspected

Primary element replaced or cleaned

Secondary element replaced (cannot be cleaned)

Secondary element replaced after every third cleaning of the primary element or annually

Latches undone and cover removed

WARNING! Pressurized fluid present in radiator. Never open radiator cap when hot

NOTE! Do not intermix different brands of coolant. If the existing coolant cannot be identified, drain and flush the remaining coolant and refill with new coolant. Refer to section 5.4-5 for instructions on changing engine coolant

Radiator filled completely through the radiator neck, until coolant is visible

Enter the time engine was run without radiator cap to achieve operating temperature

Coolant level and coolant strength in the radiator checked

Mixture adjusted as required. Refilled until coolant is visible

WARNING! Do not allow fuel tank to become completely empty. If tank is allowed to empty completely, the entire fuel system will require bleeding.

Check fuel gauge inside operator’s cab

Ensure fuel is at an appropriate level before the start of each work shift

NOTE! Refer to Operating Manual for refueling procedure

Sign off on the fuel tank maintenance

WARNING! Diesel fuel is flammable and may cause death or serious injury. Shut down engine and do not smoke while draining fuel/water separator

Ensure engine is shut down & telehandler is parked on a firm level surface

Prepare a container for draining the fuel/water separator and place it under the separator

Open drain reservoir and allow approximately one cup of fuel and any collected sediment to drain into the container

Close the drain then dispose of the collected liquid in an environmentally safe manner

NOTE! Refer to your local/national environmental regulations on how to dispose of used fuels and other dangerous liquids

Sign off on the fuel/water separator maintenance

Telehandler parked on a firm level surface with boom fully retracted and lowered?

Engine shut off and engine cover lifted open?

Wait approximately 15 minutes after engine has been shut off

Dipstick pulled out and wiped off with a clean, dry, lint-free cloth?

Dipstick placed back in the hole until it stops?

Dipstick pulled out again and oil level checked?

Oil level between the “Full” and “Low” marks?

If oil level is below the “Low” mark, refer to Section 5.4-4 for engine oil and filter replacement procedure

Sign off on the engine oil check