R.P.S. Corporation Rider Floor Scrubber GTX 30"-Cyl

Remove and clean pads or brushes

Remove and clean debris from the float shut-off screen and drain saver located inside the recovery tank

Drain and rinse tanks thoroughly

Inspect vacuum hose for any objects obstructing the air flow

Raise squeegee and wiper blades with a clean cloth

Wipe down machine if needed. Use a nonabrasive, non solvent cleaner, or a clean damp cloth

Recharge the batteries if needed

Sign off on the daily maintenance

Check scrub head and squeegee lifting cables for wear and spring tension

Check machine for water leaks and loose nuts and bolts

Check to see if battery cables are tightened (Tighten if needed)

Sign off on the monthly rider floor scrubber maintenance

Warning: Always use distilled water to refill batteries.

Battery water level in each cell

Batteries filled approximately 3/4\ to 1\" above the plates"

Battery tops cleaned to prevent corrosion

Rotate brushes. Rotate the left to the right and right to left.

On cylindrical models rotate brushes from front to back, or end to end if using different materials.

Brushes rotated on cylindrical models

Drain and rinse tanks thoroughly.

Check battery case and battery compartment for any damage or wear

Clean pivot points on squeegee and scrub deck

Check all motors for carbon brush wear

NOTE: Traction drive, wheels and batteries should be serviced based on traction drive hour meter. The scrub brush hour meter should be used for all other service schedule items.

Sign off on the 200 Hourly Rider Floor Scrubber Maintenance

Check battery cells with hydrometer

Check battery connections are tight

NOTE: Traction drive, wheels and batteries should be serviced based on traction drive hour meter. The scrub brush hour meter should be used for all other service schedule items.

Sign off on the maintenance check