Kaeser Screw Compressor AS 25

Warning: The use of an unsuitable air filter element can permit dirt to ingress the pressure system and cause damage to the machine.

Do all sealing surfaces match each other?

Is the air filter element suitable?

Note: The air filter element cannot be cleaned.

Sign off on the air filter check

Precondition: The power supply isolating device is switched off, the device is locked off, the absence of any voltage has been verified. The machine has cooled down.

Ventilation grill and filter mat carefully removed

Loose dirt removed from the mat using a vacuum cleaner or by beating

Was the mat washed with lukewarm water and household detergent?

Filter mat inserted in the frame and ventilation grill latched in

Sign off on the filter mat cleaning

Warning: Ensure the power supply isolating device is switched off, the device is locked off, and the absence of any voltage has been verified. The machine should be cooled down.

Material: Brush and vacuum cleaner, Face mask (as required)

If the cooler is clogged, contact the authorized KAESER service representative to clean the cooling air ducts.

Carefully remove the filter mat from the retaining frame.

Dry brush the oil and air coolers and use a vacuum cleaner to suck up the dirt.

Carefully insert the filter mat in the retaining frame.

If the air and oil coolers can no longer be properly cleaned, have severe clogging removed by an authorized KAESER service representative.

Sign off on the cooler cleaning

Precondition: The machine is switched off.

Filter mat removed from the retaining frame

Loose dirt removed from the filter mat

Was the filter mat washed with lukewarm water and household detergent?

Filter mat inserted in the retaining frame

Sign off on the filter mat cleaning

Do not use sharp objects to clean the refrigerant condenser. The refrigerant condenser could be damaged. Avoid creating clouds of dust.

Precondition: The power supply disconnecting device is switched off, the device is locked off, the absence of any voltage has been verified.

Did you undo the latch 5 and remove the panel 1?

Did you use compressed air (<73 psig) to blow the condenser 4 through from outside to inside and then vacuum up the dirt?

Did you replace the panel again?

The refrigerant condenser can no longer be cleaned?

If the refrigerant condenser can no longer be cleaned, have stubborn clogging removed by an authorized KAESER service representative.

Sign off on the refrigerant condenser cleaning