Hussmann Merchandiser E4

• Long life and satisfactory performance of any equipment is dependent upon the care it receives. To ensure long life, proper sanitation and minimum maintenance costs, these merchandisers should be thoroughly cleaned, all debris removed and the interiors washed down, weekly.

• To facilitate cleaning, the fan plenum is hinged. After cleaning be sure the plenum is properly lowered into position or product loss will result due to improper refrigeration.

WARNING! PREVENT INJURY. ALWAYS SHUT OFF POWER DURING CLEANING PROCESS.

• The exterior surfaces must be cleaned with a mild detergent and warm water to protect and maintain their attractive finish. Never use abrasive cleansers or scouring pads.

• The interior surfaces may be cleaned with most domestic detergents, ammonia based cleaners and sanitizing solutions with no harm to the surface.

Warning: This maintenance check requires trained personnel with PPE!

Inspect all lamp sockets and plug–receptacle connections for signs of arcing

All unused receptacles have their close-off covers securely installed

Proper cleaning procedures are followed. Lights and fans are turned off when a case is cleaned and allowed to dry before turning power back on

Pressure nozzle is not used to clean inside a case

Inspect for signs of degradation (blackened ends) in fluorescent lamps

Are there severely degraded lamps still operating?

If severely degraded lamps are still operating, replace them immediately to avoid ballast failure or excessive heat exposure to the lamp holder

Sign off on the fluorescent lamps maintenance

• Honeycombs should be cleaned every six months. Dirty honeycombs will cause merchandisers to perform poorly. The honeycombs may be cleaned with a vacuum cleaner. Soap and water may be used if all water is removed from the honeycomb cells before replacing. Be careful not to damage the honeycombs.

1. Using a flat object such as a screw driver, compress the honeycomb and remove it from its retainer.

2. Clean and dry the honeycomb.

3. After cleaning, replace in reverse order.

• The interior back panels may be removed for cleaning and to gain access to the evaporator coils. Remove the rear interior back panels as follows:

1. Disconnect the electrical power to the merchandiser.

3. Remove the lower panel first: lift the panel up, then pull forward and out.

Warning: This procedure requires trained personnel with appropriate safety equipment

Drilled out the bottom of the drain fitting completely?

Inserted coupling into drain fitting without applying PVC or ABS pipe sealer?

Installed a PVC adapter on the drip trap?

Applied primer-sealer to a stub piece of PVC pipe and inserted between coupling and adapter?

Sign off on the drain fitting replacement

• The rail lamp ballast is located in the wireway, behind the lower front panel at the left-hand end of the merchandiser.

NOTE: The switch for the rail lamp is separate from the canopy and shelf lighting. The rail lamp switch is located on the rail.

1. Disconnect the electrical power to the merchandiser.

2. Remove the lower front panel by lifting it up and out.

3. Remove screws attaching the wireway cover, then remove cover.

4. Service or replace ballast as required.

Reassemble items as they were originally installed.